Tonne à lisier neuf Slurry Tanker / Güllefass / Beczkowóz Wóz Asenizacyjny

Slurry tankers – frame construction – three-axle

Standard Specification:

The tank is made of 6mm thick sheet metal, the tank has additional reinforcement rings.

Hot-dip galvanized inside and outside.

Frame adapted with attachments for the applicator.

Inside the tank, there are 2 breakwaters with reinforcing ribs.

Compressor.

A valve that shuts off the flow of slurry to the compressor.

Manovacuometer.

Bottom or top hook.

Interchangeable hitch eye.

Mechanically adjustable side support foot, load capacity up to 4 tons.

Pipe water gauge fi 90 mm.

Top hatch fi 400mm.

Lighting installation required by traffic regulations.

Basic brake – pneumatic.

Additional hand brake.

Hose 6″ (fi 150) with a suction basket – length of the suction hose 6 m.

The rear end is opened with two stubs.

The main drain gate with a diameter of 6″ is hydraulically controlled.

6″ bottom connection with 6″ manual gate valve and 6″ Perrot quick coupling.

Spreading device – PERROT JOSKIN 6” spreader.

Side spigot 6” on the left with a 6” manual gate valve with a 6” quick coupling.

Over and under pressure safety valve.

Side connector with a plug.

Side ladder.

Metal fenders.

CE certificate of conformity.

Warning triangle, rooster.

Oil separator, noise silencer.